CONTOUR FLANGE WONT WORK IN 2014 INVENTOR

[acopeman]

Can't contour flange a profile in sheet metal which is basicly a quater of a circle with a series of pre bends on one end.

 Had problems creating the sketch as could not trim between two construction lines. I could not use the arc centre point tool either.

Had to revert back to 2013 to create my part  

[JDMather]

Attach the *.ipt file here.

Have you installed Service Pack 1?

Have you installed Update 2 for SP1?

Sounds like you might need to do a Repair Install.