Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
dpsmith85
Posts: 84
Registered: ‎03-07-2011
Message 1 of 1 (73 Views)

Content Center naming convention changed?

73 Views, 0 Replies
04-05-2012 11:13 AM

I have a question regarding the content center naming convention for the "stock" category.  I have Inventor Professional 2010 and had it installed on an old XP machine.  I recently upgraded to a new windows 7 machine and did a fresh install of Inventor.  Since I did the install I am noticing that the content center is naming the "stock" category something different.  For example, when I used to create a steel L angle the stock number would read "Angle, 2 x 2 x 3/16" now it reads "L 2 x 2 x 3/16".  I've also noticed it with flat bar that Inventor labels it 4 x 3/8 when it used to be 3/8 x 4.

 

I inherited that XP PC from an old employee and am now assuming that they had customized the content center on that computer to display what it used to.  If this is the case where do I go to set it back? 

 

Thanks for the help

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.