Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
shastu
Posts: 1,814
Registered: ‎12-10-2003
Message 1 of 4 (113 Views)

Constraints round off for positional reps.

113 Views, 3 Replies
10-01-2012 08:07 AM

When creating positional reps in Inventor 2012 SP1 it rounds them to a 3 place decimal.  So If I want the constraint to be at 1.1875 it rounds it to 1.188.  Is there anyway to change this to 4 place decimal?

*Pro
jletcher
Posts: 1,983
Registered: ‎05-18-2011
Message 2 of 4 (110 Views)

Re: Constraints round off for positional reps.

10-01-2012 08:17 AM in reply to: shastu

Have not tried but what if the document settings was on 4 place decimal does it still round it off?


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
*Pro
jletcher
Posts: 1,983
Registered: ‎05-18-2011
Message 3 of 4 (108 Views)

Re: Constraints round off for positional reps.

10-01-2012 08:19 AM in reply to: shastu

Ok just tried yeah just go to document settings and change it to 4 places and it will not round off..

 

Pic.JPG


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
Distinguished Contributor
shastu
Posts: 1,814
Registered: ‎12-10-2003
Message 4 of 4 (95 Views)

Re: Constraints round off for positional reps.

10-01-2012 10:51 AM in reply to: shastu

Thank You.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.