Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
shastu
Posts: 1,813
Registered: ‎12-10-2003
Message 1 of 4 (109 Views)

Constraints round off for positional reps.

109 Views, 3 Replies
10-01-2012 08:07 AM

When creating positional reps in Inventor 2012 SP1 it rounds them to a 3 place decimal.  So If I want the constraint to be at 1.1875 it rounds it to 1.188.  Is there anyway to change this to 4 place decimal?

*Pro
jletcher
Posts: 1,971
Registered: ‎05-18-2011
Message 2 of 4 (106 Views)

Re: Constraints round off for positional reps.

10-01-2012 08:17 AM in reply to: shastu

Have not tried but what if the document settings was on 4 place decimal does it still round it off?


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
*Pro
jletcher
Posts: 1,971
Registered: ‎05-18-2011
Message 3 of 4 (104 Views)

Re: Constraints round off for positional reps.

10-01-2012 08:19 AM in reply to: shastu

Ok just tried yeah just go to document settings and change it to 4 places and it will not round off..

 

Pic.JPG


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
Distinguished Contributor
shastu
Posts: 1,813
Registered: ‎12-10-2003
Message 4 of 4 (91 Views)

Re: Constraints round off for positional reps.

10-01-2012 10:51 AM in reply to: shastu

Thank You.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.