Inventor General Discussion

Inventor General Discussion

Reply
Contributor
nmetzger
Posts: 24
Registered: ‎08-24-2012
Message 1 of 3 (114 Views)

Constraining to a distance, Inventor 2013

114 Views, 2 Replies
12-13-2012 05:48 AM

I have attached the drawing I will be referencing. I need to set the distances of the four tabs to .50" from the edges of the part. How do I do this using constraints? 

Distinguished Mentor
john.retzlaff
Posts: 947
Registered: ‎11-03-2003
Message 2 of 3 (110 Views)

Re: Constraining to a distance, Inventor 2013

12-13-2012 06:12 AM in reply to: nmetzger

You need to attach the parts, you can't open an assembly without them.

John Retzlaff
*Expert Elite*
JDMather
Posts: 28,200
Registered: ‎04-20-2006
Message 3 of 3 (46 Views)

Re: Constraining to a distance, Inventor 2013

09-03-2013 03:06 PM in reply to: nmetzger

Have you figured out the difference between parts, assemblies and drawings in Inventor?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.