Inventor General Discussion

Inventor General Discussion

Distinguished Contributor
150 Posts
1 Kudo
Registered: ‎12-11-2003
Post 1 of 3

Constraining a peg to a groove

225 Views, 2 Replies
06-05-2012 08:18 AM

I have to constrain a peg to a groove to allow it to move guided by it.  The groove is made with a sweep of a rectangle guided by a path made of straight lines and arcs.  I am only able to constrain the peg to either the straight portions or the arc portions of the groove but not to the complete groove.  Is there any way to allow the peg to slide along the entire groove?

*Expert Elite*
28,621 Posts
2,126 Kudos
Registered: ‎04-20-2006
Post 2 of 3

Re: Constraining a peg to a groove

06-05-2012 08:29 AM in reply to: elmotors

Transistional Constraint.

Attach your assembly here.

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
*Expert Elite*
3,002 Posts
1,703 Kudos
Registered: ‎03-08-2006
Post 3 of 3

Re: Constraining a peg to a groove

06-05-2012 01:17 PM in reply to: elmotors

Hi elmotors,


As JDMather said, you'll want to use a Transistional Constraint. Attached is simple example  to reference.


I hope this helps.
Best of luck to you in all of your Inventor pursuits,

  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!