Inventor General Discussion

Inventor General Discussion

Reply
Active Member
aheiselberg
Posts: 6
Registered: ‎10-01-2012
Message 1 of 3 (514 Views)

Constrain point to curved line

514 Views, 2 Replies
11-23-2012 06:24 AM

Hi folks

 

I have an assembly with a curved line made in a sketch, and a part with a point in the bottom.

I want to constrain the point to the curved line, but the regular Constrain options wont let me do so.

Is there any work-around or a tip for this?

 

The attached pic might make it easier for you to see what I want.

 

I am making an animation with Inventor Studio, so I need this constrain, so I later on in studio can manipulate it and insert the first part into the other.

*Expert Elite*
blair
Posts: 4,486
Registered: ‎11-13-2006
Message 2 of 3 (482 Views)

Re: Constrain point to curved line

11-23-2012 02:58 PM in reply to: aheiselberg

Can you place a Work Point on the line at the point required. If so, then use the Work-Point to constain to. Or extrude the line as a surface and costrain to it. If you use the constraint distance to match the radius it will match.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 344.75
SpacePilot Pro 10.2.0 / 17.2.0.11011 / 4.17
Delta Tau Chi ΔΤΧ
Active Member
aheiselberg
Posts: 6
Registered: ‎10-01-2012
Message 3 of 3 (428 Views)

Re: Constrain point to curved line

11-28-2012 02:04 AM in reply to: blair

I couldn't figure out how to extrude the line as a surface, but I did a workaround and created the curved line as a part instead. The surface of this part was able to create the constrain, as you described. Worked perfectly!

 

Now I just have to make the part invisible, and I am good to go.

 

Thank you for you help.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.