Inventor General Discussion

Inventor General Discussion

Distinguished Contributor
Posts: 154
Registered: ‎04-07-2005
Message 1 of 2 (161 Views)

Considering Upgrading to Inventor Ultimate

161 Views, 1 Replies
10-30-2012 09:50 AM



I currently use Inventor Premium Product Design Suite.  I am considering upgrading to Inventor Ultimate Product Design Suite for the FEA capability.  For FEA I currently use Algor, the last version before they sold to Autodesk.  I went that route at the time because Inventor would only perform FEA on single parts (an ipt file) and not assemblies or weldments.  Is that still the case with Inventor's FEA capabilities?  Also, back then I believe Inventor would not perform any type of modal analysis ( natural frequencies, freguency responce spectrum ) which I did and still would have a need for from time to time.  Has that capability also been added to Inventor's FEA ability?  Lastly, what element types does Inventor's FEA have, are beam elements now included?  One last thing, does Inventor's FEA mesh complex geometries very well?


Any input from Inventor FEA users is appreciated.  I haven't been able to find much detailed information on Inventor's FEA abilities, element types, load types, analysis types, etc.



Posts: 1,968
Registered: ‎09-15-2003
Message 2 of 2 (126 Views)

Re: Considering Upgrading to Inventor Ultimate

10-30-2012 06:49 PM in reply to: m.granata

Although I've had a bit of training on Inventor's FEA, I do not use it.  However, I do know that current versions of Inventor Pro will perform FEA on assemblies.  Even though I can't answer your more detailed questions, I think that the Inventor help would give you a lot of this information (the on-line WikiHelp).


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.