Inventor General Discussion

Reply
New Member
jbort
Posts: 1
Registered: ‎09-21-2012
Message 1 of 3 (135 Views)

Combining Parts help

135 Views, 2 Replies
10-11-2012 07:23 PM

I am trying to combine these two shelled parts into one so there are basically one tube, but I can not figure out how to trim the long straight tube so it matches the curved tube, please help.

*Expert Elite*
JDMather
Posts: 27,466
Registered: ‎04-20-2006
Message 2 of 3 (121 Views)

Re: Combining Parts help

10-12-2012 04:00 AM in reply to: jbort

Sketch2 is not constrained and was apparently edited after Sketch3.

Sketch3 is not constrained to Sketch2.

Work Plane1 is not needed.

Patch is not needed.

Shell4 is not needed.  (include the end face of Extrusion2 in Shell3.

 

Read this and later I'll come back and show how the part should have been done.

http://home.pct.edu/~jmather/SkillsUSA%20University.pdf

 

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Distinguished Contributor
Ryan.Martinez
Posts: 141
Registered: ‎07-29-2011
Message 3 of 3 (108 Views)

Re: Combining Parts help

10-12-2012 05:36 AM in reply to: jbort

Here is how i did it.

PDS 2014
PDS 2015
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.