Inventor General Discussion

Reply
Contributor
Oakcutter
Posts: 11
Registered: ‎10-03-2012
Message 1 of 7 (934 Views)
Accepted Solution

Combine Extrusions

934 Views, 6 Replies
10-06-2012 07:58 AM

In Inventor 2013 I have created two solids in one part thinking I could combine the two into one part. When I click the combine button this error message rears its head, "You must have at least two bodies to combine". Looking at the browser it shows both solids as bodies, What am I doing wrong? Thanks

You didn't create Extrusion2 as separate body.

 

Walter

Workplane1 is not needed.

Sketch2 is not constrained and has sick (pink) geometry.

http://home.pct.edu/~jmather/SkillsUSA%20University.pdf

Distinguished Mentor
rdyson
Posts: 897
Registered: ‎04-11-2005
Message 2 of 7 (927 Views)

Re: Combine Extrusions

10-06-2012 02:31 PM in reply to: Oakcutter

> What am I doing wrong?

 

You didn't post the ipt.

Contributor
Oakcutter
Posts: 11
Registered: ‎10-03-2012
Message 3 of 7 (913 Views)

Re: Combine Extrusions

10-06-2012 07:49 PM in reply to: rdyson

I have now, thanks.

Valued Mentor
Valued Mentor
wh
Posts: 477
Registered: ‎12-27-2003
Message 4 of 7 (906 Views)

Betreff: Combine Extrusions

10-06-2012 10:30 PM in reply to: Oakcutter

You didn't create Extrusion2 as separate body.

 

Walter

*Expert Elite*
JDMather
Posts: 27,069
Registered: ‎04-20-2006
Message 5 of 7 (892 Views)

Re: Combine Extrusions

10-07-2012 04:48 AM in reply to: Oakcutter

Workplane1 is not needed.

Sketch2 is not constrained and has sick (pink) geometry.

http://home.pct.edu/~jmather/SkillsUSA%20University.pdf

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Contributor
Oakcutter
Posts: 11
Registered: ‎10-03-2012
Message 6 of 7 (850 Views)

Betreff: Combine Extrusions

10-08-2012 06:19 AM in reply to: wh

Thanks Walter, you were right on, appreciate all the help I can get.

Contributor
Oakcutter
Posts: 11
Registered: ‎10-03-2012
Message 7 of 7 (848 Views)

Re: Combine Extrusions

10-08-2012 06:23 AM in reply to: JDMather

JD,

 

I've gone half way thru the 60 tips and I must say what you sent is invaluable I would encourage any newbie to go thru that before doing another thing in Inventor.

 

Thanks,

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.