Inventor General Discussion

Inventor General Discussion

Reply
*Expert Elite*
GrantsPirate
Posts: 1,629
Registered: ‎08-15-2008
Message 1 of 5 (2,082 Views)

closed Navigation toolbar, can't get it back

2082 Views, 4 Replies
09-01-2009 08:06 AM
The Navigation toolbar was easy enough to close by accident. Going to Help talks all about the Navigation toolbar but never says how to get it displaying again. At least I don't see it in help.

Any ideas.

Thanks.
CO
----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.
*Expert Elite*
mcgyvr
Posts: 7,062
Registered: ‎12-01-2004
Message 2 of 5 (2,082 Views)

Re: closed Navigation toolbar, can't get it back

09-01-2009 08:14 AM in reply to: GrantsPirate
Assuming 2010 ribbon UI. Go to View..Windows section..User Interface flyout..check Navigation Bar.
Took me a while to find it also.
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

-------------------------------------------------------------------------------------
2015 Product Design Suite Ultimate
Windows 7 64 bit
Core i7 4820k processor (OC'd to 4.4Ghz), Nvidia GTX 770, 16G RAM


*Expert Elite*
GrantsPirate
Posts: 1,629
Registered: ‎08-15-2008
Message 3 of 5 (2,082 Views)

Re: closed Navigation toolbar, can't get it back

09-01-2009 08:24 AM in reply to: GrantsPirate
I should mention the version when asking questions, I am on 2010. Thanks. This transition from Autodesk to Inventor is not going smoothly, I need all the help I can get.
----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.
*Blair Stunder
Message 4 of 5 (2,082 Views)

Re: closed Navigation toolbar, can't get it back

09-01-2009 09:00 AM in reply to: GrantsPirate
Forget most of what you learned in ACAD

--
IV2010sp1 Pro-Suite
Dell 670 dual Xeon - 3.2
4gb memory, SCSI320-15k rpm
XP-Pro, sp3
Quadro FX3400: Driver: 190.38 Direct3D
SpacePilot Rel V: 3.7.18 Dvr V: 6.7.13 Firmware 3.12
AVG 8.5
wrote in message news:6246769@discussion.autodesk.com...
I should mention the version when asking questions, I am on 2010. Thanks.
This transition from Autodesk to Inventor is not going smoothly, I need all
the help I can get.
New Member
marcvmz
Posts: 1
Registered: ‎06-20-2014
Message 5 of 5 (547 Views)

Re: closed Navigation toolbar, can't get it back

06-27-2014 12:29 PM in reply to: GrantsPirate

Go to Visual Bar, and after click in User Interface, there is a Navigation Bar, click and ok.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.