Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

closed Navigation toolbar, can't get it back

4 REPLIES 4
Reply
Message 1 of 5
GrantsPirate
12497 Views, 4 Replies

closed Navigation toolbar, can't get it back

The Navigation toolbar was easy enough to close by accident. Going to Help talks all about the Navigation toolbar but never says how to get it displaying again. At least I don't see it in help.

Any ideas.

Thanks.
CO

GrantsPirate
Piping and Mech. Designer
EXPERT ELITE MEMBER
Always save a copy of the drawing before trying anything suggested here.
----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.

4 REPLIES 4
Message 2 of 5
mcgyvr
in reply to: GrantsPirate

Assuming 2010 ribbon UI. Go to View..Windows section..User Interface flyout..check Navigation Bar.
Took me a while to find it also.


-------------------------------------------------------------------------------------------
Inventor 2023 - Dell Precision 5570

Did you find this reply helpful ? If so please use the Accept Solution button below.
Maybe buy me a beer through Venmo @mcgyvr1269
Message 3 of 5
GrantsPirate
in reply to: GrantsPirate

I should mention the version when asking questions, I am on 2010. Thanks. This transition from Autodesk to Inventor is not going smoothly, I need all the help I can get.

GrantsPirate
Piping and Mech. Designer
EXPERT ELITE MEMBER
Always save a copy of the drawing before trying anything suggested here.
----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.

Message 4 of 5
Anonymous
in reply to: GrantsPirate

Forget most of what you learned in ACAD

--
IV2010sp1 Pro-Suite
Dell 670 dual Xeon - 3.2
4gb memory, SCSI320-15k rpm
XP-Pro, sp3
Quadro FX3400: Driver: 190.38 Direct3D
SpacePilot Rel V: 3.7.18 Dvr V: 6.7.13 Firmware 3.12
AVG 8.5
wrote in message news:6246769@discussion.autodesk.com...
I should mention the version when asking questions, I am on 2010. Thanks.
This transition from Autodesk to Inventor is not going smoothly, I need all
the help I can get.
Message 5 of 5
marcvmz
in reply to: GrantsPirate

Go to Visual Bar, and after click in User Interface, there is a Navigation Bar, click and ok.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report