Inventor General Discussion

Inventor General Discussion

Reply
New Member
matthew.veivers
Posts: 2
Registered: ‎07-08-2012
Message 1 of 2 (140 Views)

Changing the default Datum ID on the Datum Target from "A" to "Z"

140 Views, 1 Replies
12-04-2012 06:00 PM

We do not use "A" as our default datum ID.

Instead of manually changing this each time I place a Datum target can I change the default?

 

Regards

Product Support
Henry.Huang
Posts: 10
Registered: ‎09-15-2008
Message 2 of 2 (122 Views)

Re: Changing the default Datum ID on the Datum Target from "A" to &quo

12-06-2012 06:15 PM in reply to: matthew.veivers

I did not find where can modify the default setting, I willl document a wishlist to our DEV team and see if we can make some change here. 

 

Thank you for your information. 

 

Henry 




Henry Huang
Technical Support Specialist
Customer Service & Support
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.