Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
jleonard2500
Posts: 80
Registered: ‎04-14-2011
Message 1 of 6 (158 Views)
Accepted Solution

Changing part file in drawing

158 Views, 5 Replies
08-08-2012 07:09 AM

Is it possible to update an existing drawing to reference a new part or assembly file while maintaining associated views and possibly the annotation also? 

 

I have tasks which require frequent subtle changes to assemblies. These assemblies will then be given a completely new file name, so it is no longer just a revision change but a new part altogether.

Not in 2010.

You will need to temporarily rename the file the drawing references, then open the drawing and resolve link dialog comes up you can link to the new file, then save.

Distinguished Mentor
john.retzlaff
Posts: 947
Registered: ‎11-03-2003
Message 2 of 6 (155 Views)

Re: Changing part file in drawing

08-08-2012 07:21 AM in reply to: jleonard2500

Manage tab, replace model reference.

John Retzlaff
Valued Contributor
jleonard2500
Posts: 80
Registered: ‎04-14-2011
Message 3 of 6 (150 Views)

Re: Changing part file in drawing

08-08-2012 07:32 AM in reply to: jleonard2500

I did not see an update model reference command on the manage tab (pic attached). Is this not available on 2010?

Distinguished Mentor
john.retzlaff
Posts: 947
Registered: ‎11-03-2003
Message 4 of 6 (148 Views)

Re: Changing part file in drawing

08-08-2012 07:35 AM in reply to: jleonard2500

Not in 2010.

You will need to temporarily rename the file the drawing references, then open the drawing and resolve link dialog comes up you can link to the new file, then save.

John Retzlaff
Valued Contributor
jleonard2500
Posts: 80
Registered: ‎04-14-2011
Message 5 of 6 (145 Views)

Re: Changing part file in drawing

08-08-2012 07:50 AM in reply to: jleonard2500

Thanks.

*Expert Elite*
karthur1
Posts: 4,327
Registered: ‎04-27-2005
Message 6 of 6 (133 Views)

Re: Changing part file in drawing

08-08-2012 08:32 AM in reply to: john.retzlaff

John,

Wasn't that functionality included in the "Subscription Advantage Pack" for 2010?  The OP is probably not on subscription, but if he is that might help.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.