Inventor General Discussion

Inventor General Discussion

Reply
Active Member
texteditor
Posts: 9
Registered: ‎06-18-2007
Message 1 of 8 (1,025 Views)
Accepted Solution

Change part reference in drawing

1025 Views, 7 Replies
02-02-2013 04:01 AM

In solidworks, if I have several similar parts to draw, I can draw one part and annotate it and then to save time and effort I can save the drawing as one of the other parts and then change the part reference in the drawing as I open it up.

Is this possible in Inventor?

Thanks texteditor.

Doesn't Manage>Modify>Replace Model Reference do the same thing?

Active Member
gjohnston
Posts: 8
Registered: ‎02-08-2011
Message 2 of 8 (1,024 Views)

Re: Change part reference in drawing

02-02-2013 04:03 AM in reply to: texteditor

I do this often. Open ipt then save as new part.

Active Member
texteditor
Posts: 9
Registered: ‎06-18-2007
Message 3 of 8 (1,009 Views)

Re: Change part reference in drawing

02-02-2013 07:20 AM in reply to: gjohnston

Sorry not clear enogh in my explanation - in solidworks have 2 similar parts and do drawing of one with all sorts of views and annotations.

Then save drawing as drawing of second part and change reference in drawing to refer to second part _ drawing then opens up with similar drawing to first part but with all the views containing and referencing second part.

texteditor

Active Member
gjohnston
Posts: 8
Registered: ‎02-08-2011
Message 4 of 8 (1,004 Views)

Re: Change part reference in drawing

02-02-2013 08:21 AM in reply to: texteditor
Not that I know of. Sounds like a good idea. I'd vote for that. Have a nice day. Gerry
Distinguished Mentor
rdyson
Posts: 900
Registered: ‎04-11-2005
Message 5 of 8 (998 Views)

Re: Change part reference in drawing

02-02-2013 09:48 AM in reply to: gjohnston

Doesn't Manage>Modify>Replace Model Reference do the same thing?

Active Member
gjohnston
Posts: 8
Registered: ‎02-08-2011
Message 6 of 8 (994 Views)

Re: Change part reference in drawing

02-02-2013 10:04 AM in reply to: rdyson
I did not know that was there. Thank you so much. That should make my life easier. Have a nice day. Gerry
Distinguished Mentor
IgorMir
Posts: 519
Registered: ‎08-02-2003
Message 7 of 8 (988 Views)

Re: Change part reference in drawing

02-02-2013 04:38 PM in reply to: texteditor

Using iParts will get you what you are after.

Best Regards,

Igor.

Web: www.meqc.com.au
Active Member
texteditor
Posts: 9
Registered: ‎06-18-2007
Message 8 of 8 (973 Views)

Re: Change part reference in drawing

02-03-2013 09:52 AM in reply to: rdyson

Exactly what I wanted.

Thanks texteditor.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.