Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
scoopthepoop2000
Posts: 128
Registered: ‎02-16-2007
Message 1 of 2 (136 Views)

catching part up in .ipn

136 Views, 1 Replies
02-13-2013 07:59 AM

I am using IV 2010.  I have placed my assembly in the .ipn.  I have identical bolts that I tweaked all at once.  The only problem is I have 40 and only tweaked 39 and did not notice I left one out.  Is it possible with out tweaking that one individually to catch it up to the other 39?  I would like to keep the bolts tweaked together so if I need to move them all I need to do is drag the trail of one and the remaining will move. As of now it looks like my only way to do this is to delete all the tweaks for the first 39 and start over which I would rather not do. Thanks.

*Expert Elite*
Curtis_Waguespack
Posts: 3,000
Registered: ‎03-08-2006
Message 2 of 2 (124 Views)

Re: catching part up in .ipn

02-13-2013 09:48 AM in reply to: scoopthepoop2000

Hi  scoopthepoop2000,

 Try this:

  • Click the little filter button on the model browser and change it to Tweak View.
  • Then expand the Explosion node and locate the tweak that moved the bolts.
  • Then expand the assembly model and locate bolt #40.
  • Finally, click on bolt #40 and drag it up and drop it on the tweak node (named Translate 22.000 mm for example)

Autodesk Inventor IPN add component to tweak.png

 

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

 



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.