Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
jmartzig
Posts: 609
Registered: ‎12-01-2003
Message 1 of 1 (31 Views)

Casting question - what format?

31 Views, 0 Replies
11-18-2002 12:40 AM
hi all - i've done this in MDT awhile back with success using IGS. but i just wondered what the group was doing. i will be having a casting coming down the pipes, and have to send the file to a vendor - just wondered what export people were using to get something casted. (not sure what method of casting yet, but i wouldn't think that would matter) thanks. -Joe
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.