I am experiencing the same problem for Inventor 2013
Please can anybody help.
Mr. dash1982, The discussion forums are not only the place to take
but give as well. Its a give and take of ideas and help each other
Its my understanding - "That knowledge is the only thing which increases by sharing/giving"
I dont think this can be a solution after reading through other thread but for me with windows 7 64 bit
Inventor 2013 , I rebooted and it did the trick
Hope that might help someone else
I am getting the same error on Inventor 2013. I did not update anything and started getting this error. i also rebooted my system but no luck.
I recently found that if your C: drive (Where ever your Inventor Installation is) is out of memory
then you experience that problem. Hope that helps
Yep, that was my problem. Thanks.
Hard drive full. Inventor 2013, Windows 7. Deleted some junk then Inventor was able to open again.
The solution is to make more free space on disc where Inventor was being installed or change a path to another disc location.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!