Community
If this is a component by itself as an IPT, I would say that the primary sketch in not fully constrained if it can be move in the X and Y directions. Sounds like this is the plane that the sketch is on. The Z direction then would be your depth of the extrusion. It's placed on the XY work plane and can't move up off it.
You could post the offending part here.
Inventor 2020, In-Cad, Simulation Mechanical
Just insert the picture rather than attaching it as a file
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Delta Tau Chi ΔΤΧ
Hi!
Maybe you have a mate Constrain between th egreen element and one of the others. Open the constrains in the Inventor browser and verify that.
Did you find this reply helpful ? If so, use the 
CCarreiras
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")