Inventor General Discussion

Inventor General Discussion

Reply
Active Member
genek1
Posts: 10
Registered: ‎11-10-2013
Message 1 of 5 (547 Views)
Accepted Solution

cant move compenent along z axis

547 Views, 4 Replies
11-17-2013 04:01 PM

I made component and wan't to move it up (along z axis), but i can't. I can move it along y and x axis, but not z

Hi!

 

Maybe you have a mate Constrain between th egreen element and one of the others. Open the constrains in the Inventor browser and verify that.

 

Did you find this reply helpful ? If so, use the  Mark Solutions!  Accept as Solution or Give Kudos!Kudos - Thank you!

*Expert Elite*
blair
Posts: 4,165
Registered: ‎11-13-2006
Message 2 of 5 (517 Views)

Re: cant move compenent along z axis

11-17-2013 07:07 PM in reply to: genek1

If this is a component by itself as an IPT, I would say that the primary sketch in not fully constrained if it can be move in the X and Y directions. Sounds like this is the plane that the sketch is on. The Z direction then would be your depth of the extrusion. It's placed on the XY work plane and can't move up off it.

 

You could post the offending part here.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 340.52
SpacePilot Pro 3.17.7, 6.17., 4.11
Active Member
genek1
Posts: 10
Registered: ‎11-10-2013
Message 3 of 5 (485 Views)

Re: cant move compenent along z axis

11-18-2013 02:24 AM in reply to: blair
Yes component is saved as an ipt file.
It looks like this:
http://www.fotosik.pl/pokaz_obrazek/e00b5f9e9e24f078.html

green part is component that i want to move
Distinguished Mentor
ccarreiras
Posts: 878
Registered: ‎02-04-2010
Message 4 of 5 (479 Views)

Re: cant move compenent along z axis

11-18-2013 02:51 AM in reply to: genek1

Hi!

 

Maybe you have a mate Constrain between th egreen element and one of the others. Open the constrains in the Inventor browser and verify that.

 

Did you find this reply helpful ? If so, use the  Mark Solutions!  Accept as Solution or Give Kudos!Kudos - Thank you!

Regards.
CarlosC

Autodesk Inventor 2014 Certified Professional
Autodesk Factory Design Suite Ultimate 2015
Windows 7 64Bit
Active Member
genek1
Posts: 10
Registered: ‎11-10-2013
Message 5 of 5 (475 Views)

Re: cant move compenent along z axis

11-18-2013 02:59 AM in reply to: ccarreiras

yes that was the problem, thanks

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.