Hmmm I was just going off this previous post
All,
Just so everyone knows (I've seen this discussion before), if you go to
Application Options and the Sketch tab, and turn on "Autoproject edges
during curve creation", it will work as it did in previous releases. That
is, sketch on a view and you can constrain to the model geometry.
Just an FYI.
Rich Willis- Autodesk
--
Kent
Member of the Autodesk Discussion Forum Moderator Program
"MichaelPuschner" wrote in message news:f11f86d.3@WebX.maYIadrTaRb...
> Autoproject edges doesn't work for me in IDWs.
> (And if I think about it they aren't edges in IDWs.)
> Michael Puschner
>