Inventor General Discussion

Inventor General Discussion

Reply
*Expert Elite*
JDMather
Posts: 28,056
Registered: ‎04-20-2006
Message 11 of 12 (92 Views)

Re: CAnnot project any work planes.

09-09-2013 08:30 AM in reply to: not2013

not2013 wrote:

JDMather wrote:

 please were is this written so I may read it myself? "That you should never project work planes in sketches."

Located in the USA!


It is written in post #8, you even tried to quote me but you mis-quoted.
I wrote that I never ever project the workplanes.  I didn't write anything about others not projecting workplanes.

 

USA is a big country - perhaps I can come to your location and show you how I use the software.
I have noticed throughout your posts that you seem to be struggling.

I can save your company lots of money.

If I don't - don't pay me. 

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Distinguished Contributor
not2013
Posts: 134
Registered: ‎05-06-2013
Message 12 of 12 (65 Views)

Re: CAnnot project any work planes.

09-10-2013 08:38 AM in reply to: JDMather

Yes the struggling got worse after our change from 2011 to 2013.  Some things just do not work anymore and the total interface is unstable.

 

How would you train against this happening?  Please see attached and take a close look at the ribbon menu.

 

 

THX

 

 

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!