Inventor General Discussion

Inventor General Discussion

Reply
Contributor
payamparsa
Posts: 16
Registered: ‎07-09-2012
Message 1 of 2 (182 Views)

Cannot make part adaptive

182 Views, 1 Replies
11-18-2012 07:19 AM

1) How Can I turn on 'Adaptive' option on the menu shown in attached picture for layout part? (in assembly invironment)

2) Which process or fault leads to that problem?

 

best regards

*Expert Elite*
blair
Posts: 4,494
Registered: ‎11-13-2006
Message 2 of 2 (167 Views)

Re: Cannot make part adaptive

11-18-2012 04:42 PM in reply to: payamparsa

You would need to open/modify the part within the assembly and reference geometry from another item within the assembly.

 

Double click on the part within the IAM, then create a sketch on the surface of the part and project geometry from another item within the IAM onto the sketch and then process the sketch with a modeling feature.

 

Generally one works the other way. You create parts that reference features from other parts. This turns on the Adaptivity for that part. We then turn off the Adaptivity when we are happy with our finished model. This improves system performance of the assembly/model.

 

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 344.75
SpacePilot Pro 10.2.0 / 17.2.0.11011 / 4.17
Delta Tau Chi ΔΤΧ
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.