cannot locate PEM hardware in content center of IV2009

[Anonymous]

I have IV2099 installed and running pretty well. The content center is
accessible. However, I cannot locate any PEM hardware location. I did a
re-install of the content center area and made sure to have all categories
selected in case I did not install the correct group initially. I still
cannot find the PEM content. Has anyone else had this problem? Any
suggestions on how to solve this problem? Thank you.

Ed R

[Anonymous]

if you're using your old project file, you'll need to add the pem fastener library.

[RonnieWilkins]

Check that your project file is configured to use the Sheet Metal library.

[Anonymous]

Thanks to both you and Donovan, I now seem to have it working. The key was
as you suggested that the project file needed to be updated and the Sheet
Metal library added. Thanks again for your help.

Ed R




wrote in message news:5935677@discussion.autodesk.com...
Check that your project file is configured to use the Sheet Metal library.