Inventor General Discussion

Inventor General Discussion

Reply
*Valenti, Mark
Message 1 of 4 (36 Views)

can you "un-ipart" something?

36 Views, 3 Replies
11-24-2002 09:22 PM
Is there a way to create a standard part from an ipart?
*McConnell, Cory
Message 2 of 4 (36 Views)

Re: can you "un-ipart" something?

11-24-2002 09:25 PM in reply to: *Valenti, Mark
Derive and break the link?

--
Cory McConnell
BJ pipeline Inspection
"Mark Valenti" wrote in message
news:f12706e.-1@WebX.maYIadrTaRb...
> Is there a way to create a standard part from an ipart?
>
>
*Germer, Ole
Message 3 of 4 (36 Views)

Re: can you "un-ipart" something?

11-24-2002 09:25 PM in reply to: *Valenti, Mark
Just delete the table.
Ole

"Mark Valenti" wrote in message
news:f12706e.-1@WebX.maYIadrTaRb...
> Is there a way to create a standard part from an ipart?
>
>
*Maas, Karl
Message 4 of 4 (36 Views)

Re: can you "un-ipart" something?

11-24-2002 11:02 PM in reply to: *Valenti, Mark
if you want to keep it as a parametric feature based part and not a dumb
derived solid, then you need to save a copy of the original iPart parent,
change to the size you want within the file and then delete the table.

--
K


"Mark Valenti" wrote in message
news:f12706e.-1@WebX.maYIadrTaRb...
> Is there a way to create a standard part from an ipart?
>
>
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.