Inventor General Discussion

Reply
New Member
adanes
Posts: 2
Registered: ‎04-19-2012
Message 1 of 2 (719 Views)

Can't extrude

719 Views, 1 Replies
04-19-2012 01:35 PM

I can't extrude this piece. I know i have loops but i don't know where and how to fix them! Can someone help me?

*Expert Elite*
JDMather
Posts: 27,459
Registered: ‎04-20-2006
Message 2 of 2 (711 Views)

Re: Can't extrude

04-19-2012 01:59 PM in reply to: adanes

Violin.pngFirst thing I noticed is that your sketch is not constrained.

Place (dimensioned) symmetrical sketch points and then create your spline.

 

The vertical line on the left side isn't, well, vertical.

 

There is a very very very very sharp point midway at top.  Nothing can be manufactured with a sharp point like that.

On the other side the point isn't evey symmetrical and loops over itself. 

I recommend you read this http://home.pct.edu/~jmather/skillsusa%20university.pdf ,

then perhaps do the Vacuum tutorial in my signature before you start your part over.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.