Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
78 Posts
1 Kudo
Registered: ‎11-23-2011
Post 1 of 6

Can I supress sketch in iPart ?

126 Views, 5 Replies
03-27-2012 09:33 PM

When I create a configuration in one iPart, I have one Extrusion’s sketch link to another supressed Extrusion and cause problem.

 

  Can I supress sketch in iPart ?

 

If I can suppress that sketch and I think the problem will be solved.

 

20120328.JPG

 

Andy

 

Employee
90 Posts
8 Kudos
Registered: ‎06-07-2010
Post 2 of 6

Re: Can I supress sketch in iPart ?

03-27-2012 10:57 PM in reply to: Andy_Kuang

You could (indirectly) suppress a sketch created on the face of an extrusion by supprerssing that extrusion. So, a posible workaround is to define the sketch on a surface extrusion, and then suppress the extrusion when necessary.

Udaya Gunasena
Fusion Development
Autodesk
Valued Contributor
78 Posts
1 Kudo
Registered: ‎11-23-2011
Post 3 of 6

Re: Can I supress sketch in iPart ?

03-28-2012 01:51 PM in reply to: udayag

Hi Udaya Gunasena,

 

Thanks to have a look at this issue.

When I change my sketch4 on the surface of Extrusion 3 and my problem was solved.

I had been used Solidworks for more than 10 years, Solidworks is different, I’ll try Solidworks at home tonight and may get back to you.

 

Thanks again.

 

Andy

Distinguished Mentor
546 Posts
53 Kudos
Registered: ‎08-02-2003
Post 4 of 6

Re: Can I supress sketch in iPart ?

03-28-2012 05:37 PM in reply to: Andy_Kuang

Hi Andy,

The sketch is utilizing projected geometry from the previous extrusion, most likely. That's why it's failing. Don't project the extrusion edges. Project sketch geometry instead. That has been discuss on this forum a few days ago.

Regards,

Igor.

Web: www.meqc.com.au
Valued Contributor
78 Posts
1 Kudo
Registered: ‎11-23-2011
Post 5 of 6

Re: Can I supress sketch in iPart ?

03-28-2012 08:27 PM in reply to: IgorMir

Thanks mate!

 

Andy

Melbourne, Australia

Distinguished Mentor
546 Posts
53 Kudos
Registered: ‎08-02-2003
Post 6 of 6

Re: Can I supress sketch in iPart ?

03-28-2012 08:34 PM in reply to: Andy_Kuang

You are welcome!

Web: www.meqc.com.au
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post