Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
27 Posts
0 Kudos
Registered: ‎02-28-2011
Post 1 of 3
Accepted Solution

Can I place an empty .ipt file into an assembly then start working on it?

189 Views, 2 Replies
10-19-2012 11:09 AM

Can I place an empty .ipt file into an assembly then start working on it?

 

Or do I have to create the new part, save it, then go into my assembly and place it?

 

Thanks.

Hi conbuc,

 

If you go to the Assemble tab and use the Create button, you can choose a template to create an empty *.ipt from and place it into the assembly.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

*Expert Elite*
3,002 Posts
1,703 Kudos
Registered: ‎03-08-2006
Post 2 of 3

Re: Can I place an empty .ipt file into an assembly then start working on it?

10-19-2012 11:29 AM in reply to: conbuc

Hi conbuc,

 

If you go to the Assemble tab and use the Create button, you can choose a template to create an empty *.ipt from and place it into the assembly.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Active Contributor
27 Posts
0 Kudos
Registered: ‎02-28-2011
Post 3 of 3

Re: Can I place an empty .ipt file into an assembly then start working on it?

10-22-2012 07:16 AM in reply to: Curtis_Waguespack

That button was staring right at me...thanks!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!