Inventor General Discussion

Inventor General Discussion

Reply
Active Member
mrbunny1725
Posts: 7
Registered: ‎10-27-2013
Message 1 of 2 (304 Views)

Can i open and edit files i made on inventor pro 2014 to 2013?

304 Views, 1 Replies
10-27-2013 02:36 PM

I made these parts on inventor pro 2014 which I have at home, but my concern is that would I be able to open them at school where we use inventor pro 2013?

*Expert Elite*
JDMather
Posts: 27,498
Registered: ‎04-20-2006
Message 2 of 2 (298 Views)

Re: Can i open and edit files i made on inventor pro 2014 to 2013?

10-27-2013 03:19 PM in reply to: mrbunny1725

You cannot open 2014 files with 2013, you will need to save in a neutral format like STEP (*.stp) to open in older release.  (out of luck for *.idw files)

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.