Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
WAYNE_HOUWD
Posts: 37
Registered: ‎10-25-2011
Message 1 of 4 (698 Views)

Buckling Analysis Function?

698 Views, 3 Replies
06-12-2012 07:32 PM

I tried to find the buckling analysis from Inventor FEA but no clue. I searched here and found 1 related thread almost 4 years ago.

http://forums.autodesk.com/t5/Autodesk-Inventor/How-to-get-the-buckling-effect/m-p/2386440#M323302

 

I am wondering if Autodesk has improved some on this particular analysis for these years ?

 

 

Best Regards,

 

Wayne

*Expert Elite*
Inv_kaos
Posts: 728
Registered: ‎07-26-2007
Message 2 of 4 (691 Views)

Re: Buckling Analysis Function?

06-12-2012 08:07 PM in reply to: WAYNE_HOUWD

No not yet, still only static and modal.

Please mark as "Accept as Solution" if it answers your question or "Kudos" if you found it useful.
---------------------------------------------------------------------------------------------------------------------
Stew, AICP
Inventor Professional 2013, Autodesk Simulation Multiphysics 2013
Windows 7 x64 Core i7 32GB Ram FX2000
Mentor
safiredesignengineers
Posts: 582
Registered: ‎06-28-2008
Message 3 of 4 (572 Views)

Re: Buckling Analysis Function?

01-04-2013 04:58 AM in reply to: WAYNE_HOUWD

I would like to see buckling analysis in inventor too and i am sure many others would as well, when is it likley to happen?  is it being worked on?

 

regards Adrian

Active Contributor
Rory_M
Posts: 60
Registered: ‎04-14-2011
Message 4 of 4 (568 Views)

Re: Buckling Analysis Function?

01-04-2013 05:20 AM in reply to: WAYNE_HOUWD

Have you had a look at the column calculator? It does some buckling calcs but obviously is limited when compared to FEA techniques. It can't cope with anything other than straight extrusions either but it's better than nothing.

 

columntool.png

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.