Inventor General Discussion

Inventor General Discussion

Active Contributor
Posts: 37
Registered: ‎10-25-2011
Message 1 of 4 (685 Views)

Buckling Analysis Function?

685 Views, 3 Replies
06-12-2012 07:32 PM

I tried to find the buckling analysis from Inventor FEA but no clue. I searched here and found 1 related thread almost 4 years ago.


I am wondering if Autodesk has improved some on this particular analysis for these years ?



Best Regards,



*Expert Elite*
Posts: 728
Registered: ‎07-26-2007
Message 2 of 4 (678 Views)

Re: Buckling Analysis Function?

06-12-2012 08:07 PM in reply to: WAYNE_HOUWD

No not yet, still only static and modal.

Please mark as "Accept as Solution" if it answers your question or "Kudos" if you found it useful.
Stew, AICP
Inventor Professional 2013, Autodesk Simulation Multiphysics 2013
Windows 7 x64 Core i7 32GB Ram FX2000
Posts: 582
Registered: ‎06-28-2008
Message 3 of 4 (559 Views)

Re: Buckling Analysis Function?

01-04-2013 04:58 AM in reply to: WAYNE_HOUWD

I would like to see buckling analysis in inventor too and i am sure many others would as well, when is it likley to happen?  is it being worked on?


regards Adrian

Active Contributor
Posts: 60
Registered: ‎04-14-2011
Message 4 of 4 (555 Views)

Re: Buckling Analysis Function?

01-04-2013 05:20 AM in reply to: WAYNE_HOUWD

Have you had a look at the column calculator? It does some buckling calcs but obviously is limited when compared to FEA techniques. It can't cope with anything other than straight extrusions either but it's better than nothing.



Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.