Since Bolts nuts and key shafts are not sectioned according to standards I can´t find a way to section a shaft inside a section view without cutting through these components. I have posted in atatchment an example of the problem and a picture of what it should be like.
I have been strugling with this break out view for quite some time and haven´t figured out a way to do what I need.
Thanks in advance!
By expirementing with the below option you get some control over which items participate in a section. With it set to Never all Content Centre placed items (standard or custom) do not participate in the section.
I succeeded in getting a breakout through the shaft (so that all of the key could be seen) but I could not get the breakout hatched.
Hope it helps. Please post a solution if you find 1.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!