Inventor General Discussion

Reply
Active Contributor NTM
Active Contributor
NTM
Posts: 35
Registered: ‎11-26-2003
Message 1 of 3 (20 Views)

break out

20 Views, 2 Replies
12-09-2002 11:57 PM
Fellers,

Is is possible to do a break out in I6 on an isometric view??

Jim
Distinguished Contributor MDB
Distinguished Contributor
MDB
Posts: 326
Registered: ‎12-10-2003
Message 2 of 3 (20 Views)

Re: break out

12-10-2002 01:27 AM in reply to: NTM
Yes,

I have found it easier to use the point select in order to get the depth of the breakout. Be patient with the selection, its tempermental. Mike@RTSWright
Active Contributor NTM
Active Contributor
NTM
Posts: 35
Registered: ‎11-26-2003
Message 3 of 3 (20 Views)

Re:

12-10-2002 04:05 AM in reply to: NTM
Mike,

How do you pick a surface for sketching since it's not flat.

Jim
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.