Inventor General Discussion

Inventor General Discussion

Reply
*Expert Elite*
Cadmanto
Posts: 3,356
Registered: ‎12-07-2011
Message 1 of 2 (169 Views)
Accepted Solution

BOM- Memory Count Error

169 Views, 1 Replies
11-12-2012 07:17 AM

I have an iassembly factory that has both both iassemblies generated and checked into the vault.

Both com up fine when toggling between both of them on the factory file.

My drawing BOM was looking fine until I added a couple of items to the factory assembly file (items are in all iassemblies).  Now I get this "Member Count Error" showing up in certain line items.  Now matter how many times

I rebuild both iassemblies I can't get the BOM to generate properly.  If I toggle to the one iassembly in the factory file the opposite one shows this error message in the BOM.

I would love to know an easy method to eleviate this issue.

BOM.JPG

Best Regards,
Scott McFadden
Inventor Professional 2014
(Colossians 3:23-25)

I got it to work by deleting the iassemblies from the vault, regenerating all of the iassemblies from the factory.

Then recalling up my drawing into session.  This somehow snapped my BOM back into reading all quantities

for all iassemblies.  I wish someone had an idea for an easier method to do this and how to avoid this completely if possible.

*Expert Elite*
Cadmanto
Posts: 3,356
Registered: ‎12-07-2011
Message 2 of 2 (156 Views)

Re: BOM- Memory Count Error

11-12-2012 10:34 AM in reply to: Cadmanto

I got it to work by deleting the iassemblies from the vault, regenerating all of the iassemblies from the factory.

Then recalling up my drawing into session.  This somehow snapped my BOM back into reading all quantities

for all iassemblies.  I wish someone had an idea for an easier method to do this and how to avoid this completely if possible.

Best Regards,
Scott McFadden
Inventor Professional 2014
(Colossians 3:23-25)

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.