Inventor General Discussion

Inventor General Discussion

Reply
New Member
jkurthamt
Posts: 1
Registered: ‎11-26-2012
Message 1 of 2 (115 Views)

Bolted Connection on a Machined Face

115 Views, 1 Replies
11-26-2012 01:29 PM

Hi All.

 

I have been working on a large assembly and I am trying to get a bolted connection to pass through a component and a machined plate.  I have been using the cocentric option to complete many other holes up to this point, but not through a machined surface.

 

When I attempt this, I get two errors saying:

Design Accelerator Doctor

1. Failed to add sketch for a hole

2. Failed to create a hole

 

My questions are:

Is there a way around this Or is this a problem that I am going to have to work around?

Or

Is there a better way to get a hole/bolt through this assembly?

 

Thanks!

*Expert Elite*
JDMather
Posts: 26,602
Registered: ‎04-20-2006
Message 2 of 2 (105 Views)

Re: Bolted Connection on a Machined Face

11-26-2012 03:23 PM in reply to: jkurthamt

I don't think it will be possible to answer this question without a dataset.

Make up a simple example assembly and attach it here.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.