Inventor General Discussion

Inventor General Discussion

Reply
Contributor
valdas
Posts: 19
Registered: ‎07-03-2012
Message 1 of 2 (165 Views)

Bolt diameter is inactive in Bolt Connection Component Generator

165 Views, 1 Replies
08-07-2012 04:30 AM

Hi,

 

I have some problems with Bolt Connection Component Generator. For placement I choose Concentric, i choose all references, but I can't select Diameter. It is stuck to 10mm and i can't change it.

Am i doing it wrong or what?

I am using Inventor Profesional 2013

Print Screen

 

Thanks for answers

Contributor
AndyWallace
Posts: 14
Registered: ‎05-17-2013
Message 2 of 2 (71 Views)

Re: Bolt diameter is inactive in Bolt Connection Component Generator

10-17-2013 06:15 AM in reply to: valdas

The ENABLE CALCULATION button, upper right just under the X, is selected.

 

This just happened to me and I couldn't change hole size even though the choice was "by hole". Even though my hole in the parts was #8, the bolted connection wizard was stuck at #2 until I unselected calculations.

 

Unselect calculations and then you should be able to select a new size.

 

Oddly, now that I've unselected it, and created a bolted connection, I can't seem to duplicate the problem, even after creating a new assembly.

Andy

 

Andy Wallace
Autodesk Inventor 2014 (1 year)
previously Solidworks (6 years)
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.