Inventor General Discussion

Reply
Valued Contributor JM.
Valued Contributor
JM.
Posts: 55
Registered: ‎01-07-2011
Message 1 of 4 (230 Views)
Accepted Solution

Bill Of Material

230 Views, 3 Replies
02-24-2012 09:53 AM

Is there any way to create a seperate BOM for different views?  I can create a BOM for each but changes in 1 are duplicated in the second.

Creating BOM using views doen't help as whle the parts on the same, cut lengths vary.  The easiest solution was to do a 'save as' and create unique assemblies for each option.

*Expert Elite*
mcgyvr
Posts: 7,052
Registered: ‎12-01-2004
Message 2 of 4 (228 Views)

Re: Bill Of Material

02-24-2012 09:59 AM in reply to: JM.

It comes down to exactly what you are trying to do.

Please remember that a BOM is used in the assembly but a parts list is used on a drawing.. The are similar but there are differences.

For example you can use design view reps and then filter the parts list to only show the parts in that design view rep (but the bom has everything)

Or you can create iassemblies where your BOM (and parts list) would be different based on different configurations.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

-------------------------------------------------------------------------------------
2015 Product Design Suite Ultimate
Windows 7 64 bit
Core i7 4820k processor (OC'd to 4.4Ghz), Nvidia GTX 770, 16G RAM


Valued Contributor JM.
Valued Contributor
JM.
Posts: 55
Registered: ‎01-07-2011
Message 3 of 4 (180 Views)

Re: Bill Of Material

02-27-2012 08:17 AM in reply to: mcgyvr

Creating BOM using views doen't help as whle the parts on the same, cut lengths vary.  The easiest solution was to do a 'save as' and create unique assemblies for each option.

Distinguished Contributor
msklein
Posts: 1,454
Registered: ‎12-12-2003
Message 4 of 4 (159 Views)

Re: Bill Of Material

02-27-2012 04:08 PM in reply to: JM.

HOW about filtering by ballooning. Show only parts ballooned. should do what you want. makes no sence to me, but gets you what you want.

MSK

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.