Is there a way to form tabs along a celendrical surface? We are trying to make a bottom of a round basket and we are trying to use the sheet metal portion of Inventor so we could create a flat layout but I can not seem to use an arch as a bendline. Is this the case? We are using IV 2011.
Rolled Contour - a search here of the past couple of weeks should turn up example.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!