Inventor General Discussion

Reply
New Member
Corfu
Posts: 2
Registered: ‎11-21-2011
Message 1 of 3 (354 Views)
Accepted Solution

Bending simulation

354 Views, 2 Replies
11-30-2012 02:57 PM

Hi.

I am new to using Autodesk Inventor.

I want to know if you can make the simulation of sheet metal bending, I'm designing a bending die, and I need to simulate the folding.

thanks for help.

 

Francisco Pineda

Hi

In the Studio environment you can animate parameters(dimensions like angles).

Look for examples here in the forums.

There are some. 

Hope it helps

Dan

*Expert Elite*
Dan.M
Posts: 605
Registered: ‎01-19-2009
Message 2 of 3 (335 Views)

Re: Bending simulation

12-01-2012 03:21 AM in reply to: Corfu

Hi

In the Studio environment you can animate parameters(dimensions like angles).

Look for examples here in the forums.

There are some. 

Hope it helps

Dan

New Member
Corfu
Posts: 2
Registered: ‎11-21-2011
Message 3 of 3 (276 Views)

Re: Bending simulation

12-11-2012 11:31 AM in reply to: Dan.M

Gracias

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.