Inventor General Discussion

Reply
Valued Contributor
michael.shelley
Posts: 66
Registered: ‎02-11-2010
Message 1 of 2 (194 Views)
Accepted Solution

Bend Table Problem

194 Views, 1 Replies
12-05-2012 06:18 AM

Guys,

 

Please bend part attached. And original txt file from client

 

When I make a 90 degree bend on a model with 10mm thickness I get the following when I try to make flat patteren:

 

Create Flat Pattern (ShapeManager): problems encountered while executing this command.
Part1: Warnings occurred during update
Part1 (Flat Pattern): Warnings occurred during update
Definition1: Problems occurred while building this ASMFlatPattern
Error querying the Bend Table. The angle or radius are outside the table boundaries. The input values were: Thickness: [10,000000], Angle: [90,000000], Inner Radius [10,000000].
Error querying the Bend Table. The angle or radius are outside the table boundaries. The input values were: Thickness: [10,000000], Angle: [90,000000], Inner Radius [10,000000].
Error querying the Bend Table. The angle or radius are outside the table boundaries. The input values were: Thickness: [10,000000], Angle: [90,000000], Inner Radius [10,000000].
Error querying the Bend Table. The angle or radius are outside the table boundaries. The input values were: Thickness: [10,000000], Angle: [90,000000], Inner Radius [10,000000].

 

I have radius set to 15mm don't I?

What am I doing wrong here?

 

Thanks

 

Michael

You need to change either the radius in your part or your bend table.

 

Your bend table has a 15mm radius but your model has a 10mm radius.

 

This is the issue change one or the otheer and you are good to go..

 

Or just make another column with a 10mm radius.

*Pro
jletcher
Posts: 1,983
Registered: ‎05-18-2011
Message 2 of 2 (182 Views)

Re: Bend Table Problem

12-05-2012 07:35 AM in reply to: michael.shelley

You need to change either the radius in your part or your bend table.

 

Your bend table has a 15mm radius but your model has a 10mm radius.

 

This is the issue change one or the otheer and you are good to go..

 

Or just make another column with a 10mm radius.


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!