Inventor General Discussion

Inventor General Discussion

Reply
Contributor
sltyler
Posts: 15
Registered: ‎01-31-2014
Message 1 of 4 (281 Views)
Accepted Solution

Bend Deduction Headache with Sheet Metal

281 Views, 3 Replies
02-07-2014 02:28 PM

Hello, I'm trying to customize Inventor to create flat panel projections that are accurate to the press brake in my shop. However, I seem to be missing some piece of the puzzle when trying to figure out Inventor's bend deduction formula.

 

We bent in half an 11gauge 6" piece of 6061 aluminum at 90 degrees. The die creates an inner radius of 0.16". The resulting legs were 3 3/32" and 3 3/32". The bend deduction would be 3/16". To confirm, we took another piece at 5 3/16" and bent it up 90. The resulting legs were 3" each.


However, Inventor, using the default bend deduction formula, flat panels a model of this piece with a total length of 5.962". The 0.1492" difference really adds up after a few bends!

So, how can I modify Inventor for this need? Sorry if this seems like a condeluded question for a (possibly) simple solution or if this has been posed before (I couldn't find the solution). Any help is appreciated. Thanks in advance.

First I assume a typo, the flat should say 5 13/16 not 5 3/16

I just created a sample (see attached) of 11 ga Alum with 3 in legs and .16 bend radius

It's flat length is 5.813 using standard K-Factor of .44

Distinguished Mentor
rdyson
Posts: 896
Registered: ‎04-11-2005
Message 2 of 4 (260 Views)

Re: Bend Deduction Headache with Sheet Metal

02-07-2014 03:36 PM in reply to: sltyler

First I assume a typo, the flat should say 5 13/16 not 5 3/16

I just created a sample (see attached) of 11 ga Alum with 3 in legs and .16 bend radius

It's flat length is 5.813 using standard K-Factor of .44

*Expert Elite*
blair
Posts: 4,131
Registered: ‎11-13-2006
Message 3 of 4 (244 Views)

Re: Bend Deduction Headache with Sheet Metal

02-08-2014 08:33 AM in reply to: rdyson

this might help.

 

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 340.52
SpacePilot Pro 3.17.7, 6.17., 4.11
Contributor
sltyler
Posts: 15
Registered: ‎01-31-2014
Message 4 of 4 (230 Views)

Re: Bend Deduction Headache with Sheet Metal

02-08-2014 02:34 PM in reply to: rdyson
Thanks for the quick response. Works like a charm!
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.