Inventor General Discussion

Inventor General Discussion

Active Member
Posts: 8
Registered: ‎06-27-2012
Message 1 of 1 (200 Views)

Base view will not update in .idw

200 Views, 0 Replies
06-28-2012 01:40 PM

I made a copy of an assembly along with the .ipn and .idw files to do a component replacement.  After the replacement, all the components were updated in the .iam and .ipn files.  However, in the .idw file, the base views of the .ipn does not fully update.  As you can see in the attach document, the entire box is still red, while the updated components are grey. If there is a solution to this, I would greatly appreciate the help.


Thank you,



Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.