Inventor General Discussion

Inventor General Discussion

Reply
New Member
bakeraustin47
Posts: 2
Registered: ‎08-07-2012
Message 1 of 2 (404 Views)

Ballistic Knife Variation Help

404 Views, 1 Replies
08-07-2012 09:31 PM

I am a novice when it comes to inventor and i am trying to make my spin on a ballistic knife. instead of the classic trigger mechanism used i am using a peg/slot mechanism to fire. i need a peg less than .9 in in diameter that will slide in the "L" hole i made in the knife projectile. I would enjoy someone who could attach the peg so i can assemble it. Here are the files so you can mess with them. The cap attaches to the bottom of the handle. thanks in advance.

*Expert Elite*
JDMather
Posts: 28,246
Registered: ‎04-20-2006
Message 2 of 2 (362 Views)

Re: Ballistic Knife Variation Help

08-08-2012 06:58 AM in reply to: bakeraustin47

Many of your sketches are unconstrained and no dimensions?

What is the tap drill size for a 1.125-7 thread?

 

I recommend you start here http://home.pct.edu/~jmather/SkillsUSA%20University.pdf

Once you have the parts dimensioned I can probably help out.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.