Inventor General Discussion

Inventor General Discussion

Reply
Valued Mentor
Valued Mentor
wh
Posts: 459
Registered: ‎12-27-2003
Message 1 of 3 (141 Views)
Accepted Solution

Bad points on nuts in IAM

141 Views, 2 Replies
04-10-2014 07:24 AM

See files. 2014 and 2013 show the same issue.

Workpoints placed on part are ok, but 3 additional points placed in IAM are not. It's not only a graphics issue, distance measurements to the yellow face are different, too.

 

Walter

Employee
johnsonshiue
Posts: 2,111
Registered: ‎04-30-2008
Message 2 of 3 (107 Views)

Re: Bad points on nuts in IAM

04-10-2014 03:05 PM in reply to: wh

Hi! Walter, this is a great catch! The behavior is not right. It looks like the mid point location on this intersection edge recorded by the assembly constraint (attaching the assembly workpoint) is slightly off from its actual location. I am sending it to development for further investigation.

Many thanks!

 



Johnson Shiue (johnson.shiue@autodesk.com)
Principal SQA Engineer, Inventor
Mechanical Design
Autodesk, Inc.

Valued Mentor
Valued Mentor
wh
Posts: 459
Registered: ‎12-27-2003
Message 3 of 3 (76 Views)

Re: Bad points on nuts in IAM

04-12-2014 10:25 AM in reply to: johnsonshiue

Thanks, Johnson. No real solution is in sight for this at the moment, but I'll change the color ..

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.