Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
Billduck
Posts: 61
Registered: ‎01-26-2009
Message 1 of 3 (325 Views)
Accepted Solution

Auto constraints

325 Views, 2 Replies
05-04-2012 06:27 PM

Helping a friend. When I draw a line at the origin, it does not find the origin and snap to it, or auto apply the horizontal constraint when near horizontal. Or if I draw an L the lines are not connected. That is, I can pull one line away from the other. I can not find the settingsto correct this behavior. What's up?

My gut is telling me your constraint options for sketching are all disabled, but I’d also like you to check the sketch tab on the application options as well to make sure you’re auto-projecting the center point on sketch creation.

 

To get to the constraint options in your sketch, RMB in the graphics window while in a sketch and pick “constraint options” from the overflow menu. Please see the attached images.

 

Please mark as solved if this answers your questions or let us know if it doesn’t resolve it. Thank you.

Product Support
Daren.Lawrence
Posts: 194
Registered: ‎11-04-2003
Message 2 of 3 (291 Views)

Re: Auto constraints

05-10-2012 01:33 PM in reply to: Billduck

My gut is telling me your constraint options for sketching are all disabled, but I’d also like you to check the sketch tab on the application options as well to make sure you’re auto-projecting the center point on sketch creation.

 

To get to the constraint options in your sketch, RMB in the graphics window while in a sketch and pick “constraint options” from the overflow menu. Please see the attached images.

 

Please mark as solved if this answers your questions or let us know if it doesn’t resolve it. Thank you.



Daren Lawrence
Product Support Specialist
MFG Support - Inventor
Autodesk, Inc.


http://beinginventive.typepad.com/being-inventive/
*Expert Elite*
JDMather
Posts: 28,238
Registered: ‎04-20-2006
Message 3 of 3 (269 Views)

Re: Auto constraints

05-10-2012 03:18 PM in reply to: Billduck

Is this 2010?

Check Constraint Persistance as well (looks like Perpendicular Constriant - but isn't).

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.