Inventor General Discussion

Inventor General Discussion

Reply
New Member
Adirondac
Posts: 1
Registered: ‎11-11-2002
Message 1 of 2 (46 Views)

ATI FIRE GL8800 Certification

46 Views, 1 Replies
11-11-2002 08:24 PM
The certification for IV R6 on the Autodesk http site has a yellow triangle for all drivers for this card. (This basically means that Inventor will work in a limited number of windows or that it does not support lightweight
overlay graphics, yada, yada, yada....) But when you view the PDF {printable version} page for this card, Autodesk gives it green circles across the board. So
which is it??
*Fulford, Drew
Message 2 of 2 (46 Views)

Re: ATI FIRE GL8800 Certification

11-11-2002 10:37 PM in reply to: Adirondac
The Web page is more current. Therefore Yellow it is!

It was downgraded (cuz its an ATI :smileywink: )

- drew

--
Drew Fulford B.A.Sc. Systems Engineer
Solid Caddgroup Inc. Burlington, Ontario
Tel: (905)331-9670, Fax: (905)331-7280
Corporate: http://www.solidcadcam.com/

Member of the Autodesk Discussion Forum Moderator Program
Visit my MCAD website @ http://www.mymcad.com/



"Adirondac" wrote in message
news:f12242f.-1@WebX.maYIadrTaRb...
> The certification for IV R6 on the Autodesk http site has a yellow
triangle for all drivers for this card. (This basically means that Inventor
will work in a limited number of windows or that it does not support
lightweight
> overlay graphics, yada, yada, yada....) But when you view the PDF
{printable version} page for this card, Autodesk gives it green circles
across the board. So
> which is it??
>
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.