I know that enhansements requests get more attention if there is more interest so I will add my voice as well.
Last week I had a set of 2 crossbars with 4 components on each ent that were places at irregular distances down the length of a trailer ( about 12 sets) It would have been the ideal use of a pattern except only twice was the spacing the same.
The most effective way to 'add' your voice is to send feedback via the link I posted previously. I've only entered one request based on this thread. Each user response sent regarding a specific request is a point scored for that feature. The more points.... you get the idea
hi, I am very interested to see whether Nathan has the solution for this thread or not.
Very offen, we have to create holes around four edges of rectangular man hole. By using the pattern, we have suppress the centre holes (a lot) manually, very annoying. Just wonder who has programing solution for that.
Access a broad range of knowledge to help get the most out of your products and services.