Inventor General Discussion

Inventor General Discussion

Reply
Member
slavko.tdc
Posts: 4
Registered: ‎12-19-2009
Message 1 of 3 (53 Views)

assembly problems

53 Views, 2 Replies
01-31-2010 03:04 AM
Hi,
Why is this happening? I have a win. seven.
*Level42
Message 2 of 3 (53 Views)

Re: assembly problems

01-31-2010 04:48 AM in reply to: slavko.tdc
wrote in message news:6327615@discussion.autodesk.com...
Hi,
Why is this happening? I have a win. seven.

I would say graphics card driver update is required
*Blair A. Stunder
Message 3 of 3 (53 Views)

Re: assembly problems

01-31-2010 09:41 AM in reply to: slavko.tdc
I would think Win7 is you problem with the older release of Inventor you
have. Make sure you have all Service Pack's installed for Inventor and you
have updated all your drivers especially your graphics card.

Did you also follow all the installation procedures:
http://teknigroup.com/tutorials/InstallAdsk2009.html



--
InventorSuite 2010 Suite Pro sp2
Dell Precision 690
Dual Quad Core E5320 @ 1.86GHz
4Gb DDR SDRam - 667 Mhz, ECC
SAS 146Gb - 15k rpm
Quadro FX3500 256Mb - Driver: 191.78 Bios: 5.71.22.55.08
Direct 3D
XP Pro Sp3 3Gb/2800
Space Explorer USB, release: 3.8.3 driver 6.8.1 firmware 3.17
AVG 9.0
"Level42" <1030@btinternet.com> wrote in message
news:6327616@discussion.autodesk.com...
wrote in message news:6327615@discussion.autodesk.com...
Hi,
Why is this happening? I have a win. seven.

I would say graphics card driver update is required
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.