Inventor General Discussion

Inventor General Discussion

Reply
Member
slavko.tdc
Posts: 4
Registered: ‎12-19-2009
Message 1 of 3 (52 Views)

assembly problems

52 Views, 2 Replies
01-31-2010 03:04 AM
Hi,
Why is this happening? I have a win. seven.
*Level42
Message 2 of 3 (52 Views)

Re: assembly problems

01-31-2010 04:48 AM in reply to: slavko.tdc
wrote in message news:6327615@discussion.autodesk.com...
Hi,
Why is this happening? I have a win. seven.

I would say graphics card driver update is required
*Blair A. Stunder
Message 3 of 3 (52 Views)

Re: assembly problems

01-31-2010 09:41 AM in reply to: slavko.tdc
I would think Win7 is you problem with the older release of Inventor you
have. Make sure you have all Service Pack's installed for Inventor and you
have updated all your drivers especially your graphics card.

Did you also follow all the installation procedures:
http://teknigroup.com/tutorials/InstallAdsk2009.html



--
InventorSuite 2010 Suite Pro sp2
Dell Precision 690
Dual Quad Core E5320 @ 1.86GHz
4Gb DDR SDRam - 667 Mhz, ECC
SAS 146Gb - 15k rpm
Quadro FX3500 256Mb - Driver: 191.78 Bios: 5.71.22.55.08
Direct 3D
XP Pro Sp3 3Gb/2800
Space Explorer USB, release: 3.8.3 driver 6.8.1 firmware 3.17
AVG 9.0
"Level42" <1030@btinternet.com> wrote in message
news:6327616@discussion.autodesk.com...
wrote in message news:6327615@discussion.autodesk.com...
Hi,
Why is this happening? I have a win. seven.

I would say graphics card driver update is required
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.