Assembly positions.

[Anonymous]

Sorry, brain isn't working at the moment.

Small suspension assembly constraints set to normal working height.

Save copy as new assembly, open assembly and set to bump stop position.

Create IDW of assembly1, then create drawing view of assembly2 on same sheet and
it shows it in exactly the same position as assembly1. What am I doing wrong?

John Bilton

[Anonymous]

Is there an adaptive part that is changing sizes?

Open each assy and check, are they really in two different positions?
--
Sean Dotson, PE
http://www.sdotson.com
Check the Inventor FAQ for most common questions
www.sdotson.com/faq.html
----------------------------------------------------------------------------
------
"John Bilton" wrote in message
news:7076D2B428A02AAC104A8CD680A96849@in.WebX.maYIadrTaRb...
> Sorry, brain isn't working at the moment.
>
> Small suspension assembly constraints set to normal working height.
>
> Save copy as new assembly, open assembly and set to bump stop position.
>
> Create IDW of assembly1, then create drawing view of assembly2 on same
sheet and
> it shows it in exactly the same position as assembly1. What am I doing
wrong?
>
> John Bilton
>

[Anonymous]

Yep they are. It normally works, but I suspect there is some nasty somewhere
preventing it from working correctly - it was originally done in IV5. Will try
pack n go to new folder and try again.

John Bilton

[Anonymous]

Check in design view is it referencing the correct assembly? What happens
if you save the assembly 2 close and then create.

Kathy Johnson